Print 18 comment(s) - last by typo101.. on Jan 11 at 10:14 PM

"Mako" details

"Wahoo" details
PCI Express configuration revealed

Chile Hardware has come across more details of AMD’s upcoming RD790 chipset. The RD790 is the successor to AMD’s previously released 580X chipset, formerly known as CrossFire Xpress 3200. This time around AMD is only releasing a new north bridge. The upcoming RD790 is expected to pair with the existing SB600 south bridge.

Nevertheless, the RD790 has plenty of PCI Express lanes to go around. AMD has equipped the RD790 with 42 PCI Express lanes for plenty of expansion capabilities. Thirty-two PCI Express lanes are dedicated to two PCIe x16 slots for CrossFire operation. These lanes can be further divided to deliver four PCIe x8 slots as well. PCI Express 2.0 will be supported as well.

There will still be plenty of PCIe lanes for other devices or even more PCIe slots. As the two PCIe x16 or four PCIe x8 slots only take advantage of 32 PCIe lanes, there are ten remaining lanes with six lanes used for PCIe x1, x2, x4 slots and integrated PCIe devices and another four lanes used for the south bridge interconnect.

As far as processor support goes the RD790 supports HyperTransport 3.0 and Socket AM2+. Socket AM2+ will be the new socket used by AMD’s upcoming Stars core based processors.

It is unknown when RD790 will make its official debut; however, AMD has been shipping reference boards to manufacturers. There are two reference boards available: Mako and Wahoo. Mako is the single processor reference board with support for socket AM2 and AM2+ processors. It will consist of the RD790 coupled with the SB600. The PCI Express lane configuration for Mako is as follows: two full-speed PCIe x16 slots, one physical PCIe x16 slot with four lane signaling for physics, one physical PCIe x4 slots with two lanes shared between Gigabit Ethernet and SATA and one PCI slot.

Wahoo is the new 4x4 reference board powered by a combination of the RD790 and SB600. It will support socket 1207+ processors. Wahoo will feature a slightly different PCIe lane configuration. There will be one dedicated full-speed PCIe x16 slot while the secondary slot can be configured for x8 or x16 signaling. The third physical PCIe x16 slot will have eight PCIe lanes. Lastly it will have one PCIe x1 and one PCI slot.

All PCIe slots on RD790 based motherboards will be compatible with the PCI Express 2.0 specification.

Comments     Threshold

This article is over a month old, voting and posting comments is disabled

Yeah, so we've got lots of PCI-e lanes...
By darkavatar on 1/9/2007 11:28:16 PM , Rating: 2
Heck, even if we had 128 lanes, but two double slot graphic cards for X-fire and you won't have any space left for anything else.

What's the use of all those extra lane for?
Octo-SLI on two PCBs?

I actually created an account just to say this....

By RussianSensation on 1/9/2007 11:57:39 PM , Rating: 2
We've seen boards that are able to fit 2 crossfire cards and a physics card. For optimal performance you would want 16x lanes for each of the cards for a total of 32. I am sure as physics start to become more integrated into games and more complex an 8x lane wouldn't be out of the question. That's already a total of 40x. At the same time if it doesn't cost much more, if at all to increase the number of lanes, why not?

RE: Yeah, so we've got lots of PCI-e lanes...
By Assimilator87 on 1/10/2007 12:15:32 AM , Rating: 3
Hopefully, with all those PCI-E lanes, we can have all PCI-E slots be 16X and ditch 1X, 4X, and 8X.

By ceefka on 1/11/2007 1:46:43 PM , Rating: 2
It would give some freedom of choice, but for now it would be a little too much.

1 PCIe lane should be plenty for most soundcards and ethernet cards for that matter. RME's MADI PCI-card can handle 64 channels i/o @48KHz/24bit in full duplex. If you leave enough room for it you can have three of those (192 i/o!). 384KHz/32bits won't be here very soon. They will probably make a 4x at some point, but most soundcard manufacturers haven't even left PCI yet.

By Comdrpopnfresh on 1/10/2007 12:46:12 AM , Rating: 3
eventually there should be gigabit ethernet pci-e cards, pci-e sound and physics cards, pci-e tv tuners, and so on. With both of these cards being the beginning of the next generation (both with 4x4, and stars), they are being made to be able to adapt with possible changes in the times- whether or not those changes happen.

RE: Yeah, so we've got lots of PCI-e lanes...
By misuspita on 1/10/2007 2:28:05 AM , Rating: 2
would't be so many lanes because they can add at some point an integrated PCIe GPU? I believe that one would eat up more lanes than a "normal" device

By typo101 on 1/11/2007 10:14:39 PM , Rating: 2
I thought the whole idea of the AMD/ATI CPU+GPU was the HyperTransport? I don't see a point if it just uses PCIe lanes.

By ATWindsor on 1/10/2007 2:11:09 AM , Rating: 4
I can use PCIe-slots for a lot, what really annoys me is that most (all?) Mobos seem to lock their 16x-slots to only work with GPUs, what is the point of that? What happend to one unified arcitechture insted of AGP + PCI?

"There's no chance that the iPhone is going to get any significant market share. No chance." -- Microsoft CEO Steve Ballmer
Related Articles
ATI AMD Chipset Roadmap Detailed
October 9, 2006, 12:30 PM

Most Popular ArticlesAre you ready for this ? HyperDrive Aircraft
September 24, 2016, 9:29 AM
Leaked – Samsung S8 is a Dream and a Dream 2
September 25, 2016, 8:00 AM
Yahoo Hacked - Change Your Passwords and Security Info ASAP!
September 23, 2016, 5:45 AM
A is for Apples
September 23, 2016, 5:32 AM
Walmart may get "Robot Shopping Carts?"
September 17, 2016, 6:01 AM

Copyright 2016 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki