Print 74 comment(s) - last by jimbojimbo.. on Mar 26 at 11:57 AM

Body shops face huge costs to gear up and train for aluminum vehicle repairs

Mainstream auto manufactures have used aluminum in the construction of vehicles for a number of years. However, most of the panels on cars and truck were traditionally made from stamped steel, while in some cases hoods and trunk lids were made from aluminum.
With Ford rolling out the all-new F-150 that uses a body made 95 percent from aluminum, the future looks expensive for body shops charged with fixing vehicles after an accident. Reports indicate the costs of tools and training at body shops could soar.

The Aud A8 has been primarily constucted of aluminum for nearly two decades
That would lead to labor rates at the shops rising as well, leading to more costly repairs. Ford is blazing the trial into mainstream vehicles made mostly of aluminum, but other manufactures will follow. Making broader use of aluminum to reduce the weight of vehicle is one of the big ways that automakers plan to meet CAFE standards handed down by the White House.
Some body shops will have to invest hundreds of thousands of dollars in new training and equipment to be able to repair the aluminum used in Ford trucks. Smaller body shops might not be able to justify the cost, which could be a big benefit to dealer-owned body shops.
“Not every shop in America will be equipped to repair the new F-150,” said Dan Risley, president of the Automotive Service Association. “It’s cost prohibitive because there aren’t a lot of vehicles on the road with aluminum, so the return on investment could take a few years. When you throw aluminum into the mix, everything changes.”

The 2015 Ford F-150 will be the first mainstream vehicle to make wide use of aluminum throughout its body structure
He says that less than 20 percent of body shops will be equipped to fix aluminum body structures. Shops certified to fix high-end European brands like Porsche, Jaguar, and Audi cars that are used to working with aluminum will be the best ready to deal with the influx of new aluminum vehicles needing repairs.
Ford is not the only company that will employ extensive use of aluminum in full-size pickup trucks. General Motors announced last month that its next generation Silverado and Sierra will use the lightweight material.

Source: Detroitnews

Comments     Threshold

This article is over a month old, voting and posting comments is disabled

RE: Yup
By Motoman on 3/24/2014 8:10:33 PM , Rating: 2
You're clueless. Really, you're going to compare an engine block to the wafer-thin body panel?

I've seen and worked with plenty of sheet metal. And the irrefutable fact of the matter is that a body-panel thin sheet of aluminum is nowhere near as resilient as a comparable steel panel.

Also, you're infinitely wrong on "they just replace the panel." Sure, if you're really munched it...but there's more repairing of the original piece than just ripping it off and putting on a new panel.

RE: Yup
By MightyAA on 3/25/2014 7:39:41 PM , Rating: 2
Of coarse there are differences in grades in aluminum. I just said 'engine block' because it seems like most people here are thinking pop can and how easily it's crushed. You even allude to 'wafer thin' like it's a sheet of tin foil. Most wheels are a aluminum blend now too. Oh no, they'll crush I tell ya... And although you can get them straightened, it'll probably cost just as much just to replace them if you hit a pothole too hard.

And of coarse it's not as easy as just popping off a panel and slapping on a new one. But the arguments seemed to be headed into this idea of some guy with a hammer pounding away to remove dents. That's not how it's done for anything more than a door ding.

“So far we have not seen a single Android device that does not infringe on our patents." -- Microsoft General Counsel Brad Smith

Copyright 2016 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki