Ford, GM Join Forces for 9-, 10-Speed Automatic Transmissions
April 15, 2013 9:32 AM
comment(s) - last by
Automakers hope to save millions of dollars with joint development
Ford and General Motors have announced that they have teamed up to jointly develop a new generation of advanced 9- and 10-speed transmissions that will be used in cars, crossovers, SUVs, and trucks.
The automakers say that the new transmissions will increase both performance and fuel economy. Engineering and development work for the transmissions is currently underway.
“Engineering teams from GM and Ford have already started initial design work on these new transmissions,” said Jim Lanzon, GM vice president of global transmission engineering. “We expect these new transmissions to raise the standard of technology, performance and quality for our customers while helping drive fuel economy improvements into both companies' future product portfolios.”
Automakers need every edge they can get to meet the looming
federal CAFE guidelines
set to go into effect over the next several years. With a greater number of gear ratios available in the transmission, the engine can operate at more efficient RPMs, which in turn leads to improved fuel economy.
Some industry analysts believe that a nine-speed automatic transmission could increase fuel economy by five to ten percent compared to the same vehicle using a six-speed transmission.
The two companies have collaborated on transmission technology in the past. Ford and GM previously collaborated to build a six-speed transmission for front-wheel drive cars. Ford currently uses the six-speed transmission and vehicle such as the Fusion and Edge. GM uses the transmission in the Malibu and Cruze among others.
Chrysler is currently using an
eight-speed automatic transmission
in some of its automobiles, including its popular line of trucks.
This article is over a month old, voting and posting comments is disabled
RE: Continuously Variable Transmission (CVT)
4/19/2013 8:55:46 AM
I put 100,000 miles on 2003 Nissan Murano. That thing had a standard transmission fluid cooler in radiator, a stacked plate heat exchanger cooler that actually bypassed the engine (ie coolant can go through engine or transmission cooler) that was electronically controlled and a huge air scoop and fins on the transmission pan. I'm no expert but I would say that much heat in the fluid indicates it is less efficient than a standard automatic.
I researched them quite a bit before I purchased this car. The Xtronic CVT Nissan uses relies on a metal belt made up of a few steel cables and circular stack of interlocking trapezoidal metal plates. Torque is transferred on the push side of the belt. The best description I found was imagine pushing a rope, when pushed the rope becomes stiff. The metal plates interlock and the driven pulley is 'pushed' by the drive pulley. It's very ingenious and requires very careful control of the hydraulic pressure inside the two variable diameter pulleys the belt rides on.
CVT's by their very nature must rely on friction to transfer torque, hence the heat I imagine.
As far as my subjective opinion. CVT's dull the driving experience. I think they have their place in economy cars but not for enthusiasts or sport oriented driving. WOT acceleration is a painful, droning thrash stuck at 6500 rpm, ugh! The Murano was certainly fast enough for long distance travel and passing zones but not much fun on twisty roads. I'll take my old 5 speed M3 any day over this modern technology.
I'm glad to see more gears being developed. Solves the economy problem of needing a super overdrive gear without the soul-less droning engine you get with a CVT.
BTW, the torque converter lock up clutch in most modern automatics makes them almost as efficient as a manual at cruising speeds. We've had those for 15 years.
RE: Continuously Variable Transmission (CVT)
4/19/2013 2:46:57 PM
DISCLAIMER: I am speaking for myself and not my employer.
I'm not 100% sure on the Murano CVT thermal management design, but I can tell you this: car makers hate to put duplicate or redundant systems unless they absolutely have to. So if there are two coolers, chances are - there's a REALLY good reason why both would exist (and switching between one to another is probably also due to a REALLY good reason (out of necessity) and not because they feel like it.)
Yeah, that's pretty much how double conical CVTs work. (Sorry, I always keep thinking that that's just general knowledge, but maybe it isn't.) Uh...the pressure controller probably isn't as accurate as you might think is necessary.
The thing that people forget is that everything is designed with a reason/purpose in mind. If you're trying to hit 54.5 mpg with a 6-speed, it's going to be INCREDIBLY difficult for you.
The fundamental operating principle/reason why CVTs were invented was to always be running at the peak/optimial efficiency at a given load with a given torque output/transfer. It was supposed to be about peak efficiency, but people being people - were complaining about how they don't feel the shifts blah blah blah, so we had to change the shift program to deal with that and take it away from its true purpose.
I LOVE how people think that accelerating MUST mean that your revs change instead of revving the piss outta the engine while the torque is being transferred in a controlled manner. It's no different (in principle of operation) as slowly letting out the clutch on a traditional manual. *rolls eyes*...sigh....
CVTs make it "dull" because you can't have a discontinuous torque function. You don't get the abrupt changes in torque like you do with discrete gears. In theory, there's nothing that says that you can't design the control algorithm to allow for rapid changes to the conical controller, but you might end up with jerky shifting under normal operation (cruising), which now adds the complexity of having a variable pressure valve in the hydraulics which also now means you need a controller for the valve assembly AND the controller for the conicals. Which means extra cost. Which people don't want to pay for.
Some AMTs/SMTs have electrohydraulic clutch packs that make the entire transmission more efficient than traditional manuals. And they're also already working on an e-clutch (in case people here aren't aware of that). It's been going on for a few years actually.
"There's no chance that the iPhone is going to get any significant market share. No chance." -- Microsoft CEO Steve Ballmer
White House Finalizes 54.5 MPG CAFE Standards for 2017-2025 Model Years
August 28, 2012, 2:52 PM
Chrysler Takes Fuel Economy Seriously With New V6, 8-speed Auto in '13 Ram 1500
August 24, 2012, 10:18 AM
Study Predicts Self-Driving Vehicles Could Rake in Billions
March 6, 2015, 8:34 AM
Dual-Motor Tesla Model S P85D's "Insane Mode" Shocks Passengers
January 28, 2015, 11:18 PM
2016 Cadillac CTS-V Packs 640 hp Punch with 200 mph Reach
January 23, 2015, 3:25 PM
BMW Testing Tech to Allow Users to Auto-Park, Summon Cars Via Smartwatch
December 16, 2014, 9:30 AM
Lamborghini Offers Up $6,000 Leather-Bound Android Smartphone
December 12, 2014, 3:12 PM
Quick Note: GM Teases Next Generation Chevrolet Volt
November 20, 2014, 3:26 PM
Most Popular Articles
America's Largest Cable Company, Comcast, Sees Internet Subscriptions Pass TV
May 4, 2015, 2:46 PM
Don't Spy on Me: Senate Pushes Obama's PATRIOT Act Renewal Bid to the Brink
May 25, 2015, 8:21 PM
Buzzfeed, NatGeo, NBC, and NYT Pay to Push Stories to Your Facebook Feed
May 13, 2015, 4:31 PM
Chromebooks Expected to See Sales Grow 26 Percent to 7.3 Million Units This Year
May 22, 2015, 1:26 PM
Report: Ninth Generation iPhones Get Force Touch
May 26, 2015, 2:08 PM
Latest Blog Posts
Sceptre Airs 27", 120 Hz. 1080p Monitor/HDTV w/ 5 ms Response Time for $220
Dec 3, 2014, 10:32 PM
Costco Gives Employees Thanksgiving Off; Wal-Mart Leads "Black Thursday" Charge
Oct 29, 2014, 9:57 PM
"Bear Selfies" Fad Could Turn Deadly, Warn Nevada Wildlife Officials
Oct 28, 2014, 12:00 PM
The Surface Mini That Was Never Released Gets "Hands On" Treatment
Sep 26, 2014, 8:22 AM
ISIS Imposes Ban on Teaching Evolution in Iraq
Sep 17, 2014, 5:22 PM
More Blog Posts
Copyright 2015 DailyTech LLC. -
Terms, Conditions & Privacy Information