Print 62 comment(s) - last by meef.. on Sep 10 at 5:31 AM

VW engine will be the first 4-cylinder in the industry to use cylinder deactivation tech

With more stringent fuel economy standards looming in the U.S. and elsewhere, auto manufacturers are looking to pull out all the stops to improve economy as much as possible. Carmakers are turning to technology like direct injection and automatic start/stop. Several automakers are also using cylinder deactivation on their larger engines.

Cylinder deactivation is something that some carmakers in the U.S. and abroad have used for years. Chrysler has used the technology in its Hemi engines, Honda uses it on some of its V6 models, and Audi will use cylinder deactivation in its new line of “S” performance models.

VW is set to make a first in the automotive market by offering cylinder deactivation on its 4-cylinder models.

The VW tech will turn off two engine cylinders under certain conditions. The engine is called the 1.4L TSI and VW promises that it will offer a fuel savings of 0.4-liters/100km and when combined with start/stop technology the vehicle would save 0.6-liters of fuel. For those more familiar with U.S. mpg ratings, that works out to an improvement of in the range of 
3 to 4.5 mpg on average. 

The engine would turn off two of the cylinders under low to medium loads, and VW says that the tech will meet the future European EU6 emissions standards. The cylinders will be deactivated when the engine is operating between 1,400 and 4,000 rpm and the engine torque is in the range of 25 to 75Nm.

VW claims that operating range applies to about 70 percent of the driving distance in the EU fuel economy driving cycle. VW also points out that as soon as the driver presses the pedal the cylinders will reactivate without the driver being able to tell it happened. The cylinders also would not turn off if the vehicle were being driven in a sporty manner apparently. 

Comments     Threshold

This article is over a month old, voting and posting comments is disabled

RE: Good on paper..
By FreeTard on 9/9/2011 3:46:46 AM , Rating: 2
You get 30k miles on your tierod??? I'm jealous I've got an 08 Wrangler. I get 9k on my ball joints, wheel bearings at 15k, and a differential that sucks in water at every puddle. Oh, let's not forget the MINIVAN engine on a vehicle shaped like a brick. Oh yeah and the transmission that runs too hot from the factory, with no sensor to warn you that you're overheating... you only find out after you've caught fire. Or the transmission cooler that was designed to leak oil. I could go on all day about how much I'd love to punch a Chrysler engineer in the balls.

I only bought the Jeep because it was a Jeep and because I can replace every part of it with a 3rd party. The only decent factory part is the frame... but I'm sure it sucks too. I wish they had sold it to Toyota. I curse those Chrysler pricks every time I work on the heap. Who in their right mind would decide to put 17mm bolts on one shock, and 7/8ths bolts on the other (on the rear). Who in their right mind would decide that a 16mm bolt is close enough to a 9/16th bolt hole on the track bar and control arms, thus destroying the bolt holes? Oh, a Chrysler engineer would.

10,000 parts all from the lowest bidder.

"Nowadays, security guys break the Mac every single day. Every single day, they come out with a total exploit, your machine can be taken over totally. I dare anybody to do that once a month on the Windows machine." -- Bill Gates

Most Popular ArticlesAre you ready for this ? HyperDrive Aircraft
September 24, 2016, 9:29 AM
Leaked – Samsung S8 is a Dream and a Dream 2
September 25, 2016, 8:00 AM
Inspiron Laptops & 2-in-1 PCs
September 25, 2016, 9:00 AM
Snapchat’s New Sunglasses are a Spectacle – No Pun Intended
September 24, 2016, 9:02 AM
Walmart may get "Robot Shopping Carts?"
September 17, 2016, 6:01 AM

Copyright 2016 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki