National Lab Produces Highly Efficient Waste Heat Generators
May 17, 2011 12:20 PM
comment(s) - last by
The Oak Ridge National Laboratory waste heat generator relies on thousands of tiny piezoelectric cantilevers, similar to this one, produced at the École Polytechnique Fédérale de Lausanne (EFPL).
Tiny cantilever generators could recycle as much as 30 percent of the heat chips put off
Oak Ridge National Laboratory
located about 23 miles south west of Knoxville, Tennessee has a storied history as the home of the Manhattan Project and birthplace of the atomic bomb. Today it has its sights set on many more tiny objectives, only this time it hopes to provide the world with cleaner energy, rather than destructive power.
The scientists at ORNL estimate that billions of dollars is lost every year in waste heat from electronic devices like central processing units (CPUs). Server farms spend millions a year to simply cool down their fields of racked computers. Waste heat is also
a major source of energy loss in automobiles
To that end, a team led by Scott Hunter has
[press release] tiny piezoelectric generators that use a tiny cantilever, approximately 1 mm^2 in size. Approximately 1,000 of these tiny generators can be affixed to a 1 inch^2 CPU. Each tiny generator pumps out 1 to 10 milliwatts -- and together they can produce enough electricity to partially power fans or system sensors.
While that might not sound like much, it's actually significant progress.
long hoped to use piezoeletric generators
to recycle waste heat, but past designs have struggled with efficiencies, only able to convert between 1 and 5 percent of the waste heat to electricity. By contrast Professor Hunter's design has an efficiency of between 10 to 30 percent. The exact efficiency is dependent on the temperature of the waste heat generator (computer chip).
The tiny generator works using widely known physics principles. The tiny cantilever, anchored to the piezoelectric substrate bends due to the bi-material effect when heated. This is the same effect that traditional room thermostats rely upon.
As the cantilever bends it touches the heat sink, cooling it. It then flops back down on the hot surface. This flopping creates vibrations in the piezoelectric material that creates an alternating flow of current, which can be converted to usable DC current.
Describes Professor Hunter, "The tip of the hot cantilever comes into contact with a cold surface, the heat sink, where it rapidly loses its heat, causing the cantilever to move back and make contact with the hot surface. The cantilever then cools and cycles back to the cold heat sink. The cantilever continues to oscillate between the heat source and heat sink as long as the temperature difference is maintained between the hot and cold surfaces."
The key to higher efficiencies was to
pick the right material
and the right physical design. Professor Hunter comments, "The fast rate of exchange in the temperature across the pyroelectric material is the key to the energy conversion efficiency and high electrical power generation."
This kind of piezoelectric device is part of a growing class of devices known as micro-electrical-mechanical systems (MEMS). Professor Hunter envisions his new MEMS device being installed inside PC and server coolers, saving businesses and home users money on their power bills.
By improving the efficiency of electricity usage, the devices would also reduce fossil fuel usage. Comments Professor Hunter, "In the United States, more than 50 percent of the energy generated annually from all sources is lost as waste heat, so this actually presents us with a great opportunity to save industry money through increased process efficiencies and reduced fuel costs while reducing greenhouse gas emissions."
As the device is still pretty expensive, presumably, Professor Hunter is eyeing high-performance systems as the first target for commercial deployment. The tiny generator would allow additional cooling not currently available with a traditional block water-cooled system. By offering greater cooling to the chip, high performance mainframes could be run at higher speeds than ever before, a perfect proving ground for the new MEMS device.
Nickolay Lavrik, Thirumalesh Bannuru, Salwa Mostafa, Slo Rajic and Panos Datskos were among the other researchers who worked on the device for ORNL. The project was the the
Laboratory Directed Research and Development program
under the auspice of the
U.S. Department of Energy
This article is over a month old, voting and posting comments is disabled
RE: Anybody Else...
5/18/2011 5:50:18 PM
Not really since a gas generator IS a device that generates specific gases. It is only when it is read in context that you make he selection of generator of gas or gas powered generator. The second is more common so the word powered is simply assumed until context says otherwise
A Waste Heat Generator in the context of the article is a Waste Heat
generator. Actually it is a waste heat powered electricity generator :P
The article clears up the ambiguity right at the beginning so even the laziest of readers should not be confused by it :)
"There is a single light of science, and to brighten it anywhere is to brighten it everywhere." -- Isaac Asimov
New Material Can Convert 14 Percent of Waste Heat to Electricity
January 19, 2011, 7:53 PM
Up in Smoke: Germans Develop Exhaust Pipe Power
June 6, 2008, 3:01 PM
Promise of Thermoelectric Materials on the Rebound
November 27, 2007, 2:32 PM
Quick Note: QNAP Announces $129 QGenie 7-in-1 NAS for Mobile Users
July 14, 2014, 9:32 AM
Apple Launches 21.5” iMac with 1.4GHz Core i5 Processor Priced at $1,099
June 18, 2014, 8:07 AM
Lowe's "Holoroom" Brings Holodeck, Home Improvement Dreams Closer to Reality
June 13, 2014, 9:06 AM
Intel to Broaden Market for Fanless Tablets, Ultrabooks with 14nm Intel Core M
June 3, 2014, 10:42 AM
ZOTAC Announces Four New Silent ZBOX Mini-PCs
June 2, 2014, 9:21 AM
ZOTAC Announces Funky ZBOX Sphere OI520 Series
May 22, 2014, 8:20 PM
Most Popular Articles
Microsoft Kills Entertainment Unit, May Shelve Flagship Lumia "McLaren"
July 18, 2014, 7:40 PM
JJ Abrams Unveils X-Wing Starfighter for New "Star Wars" Movie
July 21, 2014, 12:24 PM
Ford Details ’15 F-150’s 325hp, 2.7L EcoBoost V6; Demonstrates 732-lb Weight Loss
July 22, 2014, 6:55 PM
Comcast Memo: Harassing Customers During Retention Calls Actually IS Our Policy
July 22, 2014, 5:19 PM
Motorola Moto G Successor Reportedly Uncovered, Moto X Discounted by up to $75
July 21, 2014, 1:11 PM
Latest Blog Posts
Space Terrorism is a Looming Threat For the United States
Apr 23, 2014, 7:47 PM
Facebook Aims to Provide Internet to "Every Person in the World" with Drones, Satellites
Apr 1, 2014, 10:20 AM
Retail Mobile Sites Experience Outages in Light of Simplexity's Bankruptcy
Mar 14, 2014, 8:48 AM
Tesla vs. BMW: Who Has the Safer EV?
Feb 1, 2014, 2:56 PM
Justice Leaks Details of Next HTC One Two Flagship Phone
Dec 5, 2013, 4:04 PM
More Blog Posts
Copyright 2014 DailyTech LLC. -
Terms, Conditions & Privacy Information