Print 25 comment(s) - last by PrezWeezy.. on Oct 21 at 1:25 PM

Fewer reasons remaining against SSD adoption

Limited write endurance is one of the factors that detractors bring up with regards to solid state drives (SSDs). Most NAND flash chips using multi-level cell (MLC)technology in SSDs have a write endurance of around 10,000 cycles. That isn't as great a problem in SSDs greater than 120GB that use wear-leveling technology, but smaller sized SSDs have less capacity and will reach the upper limit much quicker.

That issue is why almost all SSDs aimed at the corporate and enterprise market use Single Level Cell flash chips, which typically have a write endurance around the 100,000 cycle mark. These include Intel's X25-E, OCZ's Vertex EX and Agility EX series, and Super Talent's MasterDrive RX series.

Micron Technology is one of the key partners in IM Flash Tech along with Intel Corporation. IMFT produces the 34nm NAND flash used in Intel's second generation X25-M SSDs using 2-bit-per-cell MLC chips. Micron and IMFT have been working on improving the write endurance of their NAND chips, and they have now reached a breakthrough.

“By leveraging our mature 34nm NAND process, Micron has developed Enterprise NAND products that support customers’ high-endurance requirements. These products ensure that enterprise organizations have a highly reliable NAND flash solution – be it MLC or SLC – for design into the broader enterprise storage platform,” said Brian Shirley, Vice President of Micron’s memory group.

The company’s new 32Gb MLC Enterprise NAND devices achieve an impressive 30,000 write cycles. They are also introducing a 16Gb SLC Enterprise NAND device that achieves 300,000 write cycles. The new chips also support the ONFI 2.1 synchronous interface, making them easier to integrate into new products.

Both of these new chips are built on the 34nm process which IMFT introduced last year, and can be configured into multi-die, single packages supporting densities of up to 32GB for MLC NAND and 16GB for SLC NAND.

Micron is now sampling its Enterprise NAND products with customers and controller manufacturers, and is expected to enter volume production at the beginning of 2010.

Comments     Threshold

This article is over a month old, voting and posting comments is disabled

RE: Cycle counting
By PrezWeezy on 10/19/2009 8:31:44 PM , Rating: 2
The way Intel does wear leveling is by actually putting 80 GB on the drive, then telling the OS it has ~74 GB. It's the old 1000 vs. 1024 standard that they use to calculate the amount of extra chips. IE if you had a rotational "80 GB" drive you end up with ~74 GB as calculated by the OS. So the Intel SSD tells the OS it has the 74 GB usable, then uses their wear leveling algorithm to decide where to write the data the most efficient way.

RE: Cycle counting
By jordanclock on 10/20/2009 3:02:16 AM , Rating: 2
Not quite. What SSD manufacturers do for wear leveling is basically intentionally fragment the drive. Since random access time is the same as sequential, fragmentation doesn't matter much. So with that in mind, they spread out the writes to all parts of the drive. This means that no one area is likely to fail before the rest.

As for the 80GB drive formatting to 74GBs, yes. It's the classic issue of different ideas of kilo/mega/giga. Also, SSDs have sort of "extra" cells. They aren't normally available, but as cells fail, they are activated for use by the firmware. This means storage capacity remains about the same as cells fail for a bit, instead of dropping.

RE: Cycle counting
By SAnderson on 10/20/2009 3:59:42 PM , Rating: 2
Correct. How else do you get 80/160GB from a 16/32 Gb Chip? Its one of the way Intel designs the controller to help deal with write alg. and the pesky way Flash deletes data. Extra space is available for the controller to use but only 80GB is available. And yes once some cells fail, you will still have 80GB of good cells to use, thus GREATLY increasing the average cycling per cell. Say you have 90GB of cells worth of cycling but with only 80GB of data spread across it.

RE: Cycle counting
By PrezWeezy on 10/21/2009 1:23:37 PM , Rating: 2
I think if you use 5x16GB chips you end up with 80 GB...And if I'm not mistaken 10x16 still equals 160.

RE: Cycle counting
By PrezWeezy on 10/21/2009 1:25:19 PM , Rating: 2
Go read the SSD Relapse at Anandtech. he explains it very well how the wear leveling works. It is, in fact, an 80 GB drive. It does report 74 GB to the OS and it uses the other 6 GB for it's wear leveling and "extra" cells you are talking about.

"Mac OS X is like living in a farmhouse in the country with no locks, and Windows is living in a house with bars on the windows in the bad part of town." -- Charlie Miller

Most Popular Articles5 Cases for iPhone 7 and 7 iPhone Plus
September 18, 2016, 10:08 AM
No More Turtlenecks - Try Snakables
September 19, 2016, 7:44 AM
ADHD Diagnosis and Treatment in Children: Problem or Paranoia?
September 19, 2016, 5:30 AM
Walmart may get "Robot Shopping Carts?"
September 17, 2016, 6:01 AM
Automaker Porsche may expand range of Panamera Coupe design.
September 18, 2016, 11:00 AM

Copyright 2016 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki