Print 23 comment(s) - last by michael67.. on Oct 5 at 2:42 PM

Poor quality controllers to blame, says Samsung

DailyTech reported several days ago that SSD manufacturers have been having problems with Samsung's latest generation of 32nm NAND flash. The new chips have slow write speeds, thus making them unsuitable for use in SSDs since that is one of the major advantages that the new drives have over conventional hard drives. 

We have received a reply from Samsung confirming the issue, stating that "for quality SSDs, every NAND process geometry upgrade requires a matching upgraded controller.  Should (Samsung's) 30nm-class NAND be used with a conventional controller of insufficient quality, performance slowdowns are indeed possible".

Flash memory stores information in arrays of memory cells made from floating-gate transistors. As these transistors scale to smaller process geometries, it becomes harder for electrons to flow. This sometimes causes errors in writing to memory cells which must be corrected through ECC (Error Correcting Code). ECC is typically handled on the flash controller, which may be overloaded by excessive write errors if it is not sufficiently powerful enough. This is the most likely scenario for what is happening.

Companies we spoke with confirmed similar problems with 32nm flash from Toshiba that had been overcome. Intel is using 34nm flash from IMFT that was delayed from mass production for six months, possibly due to a similar problem as well.

Most of the SSD manufacturers we spoke with had paired Samsung's flash with Indilinx's Barefoot flash controller. There are several iterations of the Barefoot controller out there for different SSDs, and no doubt Indilinx is working on the problem. However, it might take a while, and sharp price drops on SSDs are unlikely for several months.

Meanwhile, Samsung is currently in the process of completing a new flash controller revision for their own line of SSDs, and have not released any SSDs of their own using the new flash memory. Samsung states: "We spend many months developing and then fine-tuning the controller and firmware technology for our SSDs, working very closely with most of the major PC OEMs".

Comments     Threshold

This article is over a month old, voting and posting comments is disabled

RE: Errors?
By MatthiasF on 10/4/2009 6:29:16 PM , Rating: 1
Most important? Hardly. Access time is a negligible overhead margin for most hard drive operations. When the average file on a computer is 200 KBytes and bigger, a 5 ms access time is barely noticeable. The larger the average file, the less important the medium's access time.

Transfer rate is the most noticeable improvement from a storage medium.

Low access times really only benefit high IOPs situations that I doubt exist on a "typical home-computer".

RE: Errors?
By geddarkstorm on 10/5/2009 2:37:16 PM , Rating: 2
Really? You seriously believe that? Ok. Well, take a look at this then

RE: Errors?
By michael67 on 10/5/2009 2:42:32 PM , Rating: 2
Until you install a SSD in your own system ore worked on one that has one you properly would never know how fat these little baby's are.

I have 3 vertex SSDs in my systems one 60GB as my system disk in my main system, One 30GB in my HTPC, and one 30GB i use between systems on a eSATA/USB ICYBOX that fits in a a 3.5" slot for games that i play on both PCs, so i can easily swap the disk between PCs.

Roughly boot and load times have halved, also auto-save's are less irritating.

Yes $500 is a lot of money on hard drives, but Rapors ain't cheap aider and not even half as fast as SSD (and yes i had a Raptor), and this has bin one of the most useful upgrades i ever done in price performance upgrades.

And o yeah there silent to!

"Nowadays you can buy a CPU cheaper than the CPU fan." -- Unnamed AMD executive

Copyright 2016 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki