Print 66 comment(s) - last by winterspan.. on Jun 28 at 10:16 PM

One screenshot is worth a thousand words, in this case.  (Source: The Windows Club forums)
Hacker is eager to push the new OS onto a Pentium system next

Microsoft recently released a tool that suggests to users whether or not to upgrade to Windows 7, Microsoft's hot new OS.  However, it appears that the actual hardware requirements may be much lower than Microsoft's suggestions if you have enough determination.

A user on The Windows Club's forum has cooked up the ultimate low-end Windows 7 setup.  The user who goes by "hackerman1" has managed to squeeze a working, bootable Windows 7 install onto a machine with a blazing fast 266 MHz Pentium II processor, a whopping 96 MB of SDRAM memory, and a high-tech 4 MB video card. 

The enthusiast first used 128 MB of RAM, then pushed the total down to 96 MB.  A subsequent push for 64 MB proved too much -- Windows 7 needs at least 96 MB to function properly.

Not to be content, the user is now working on a new setup, trying to install Windows 7 on a Pentium I machine featuring a 166 MHz CPU paired with a 1 MB graphics card.  He's also considered trying to make the new fancy graphics wrapping -- Aero -- work on the Pentium II setup. 

Don't expect a quick install, though -- a Pentium III-based system install took 17 continuous hours, and the Pentium II install likely took much, much more.  The Pentium III based system boots in a mere 17 minutes.

While perhaps not very practical, hackerman1's quest/obsession with putting Microsoft's newest on some rather outdated hardware provides a nice illustration of the new OS's smaller footprint.  The new OS is reported to have consolidated processes, lowered memory requirements, and reduced install size from Windows Vista, allowing it to be installed on netbooks and other non-Vista-ready machines.

Comments     Threshold

This article is over a month old, voting and posting comments is disabled

RE: Article has a misleading title
By omnicronx on 6/23/2009 1:25:03 PM , Rating: 2
Hes somewhat right.. Older machines had a limit of 528M, but that was a bios limitation, not a CPU limitation. You had a DX which was the fastest and last 486 model, but I had one of the original 486's and it did have the hard limit, not that it mattered to me, my HD was only 100M =D.

RE: Article has a misleading title
By Proxes on 6/23/2009 1:40:35 PM , Rating: 3
You might want to check your 486 history.

All 486's are either SX or DX from the 25 on up to the 100.

The DX4s were the "fastest and last" as you put it. The DX2/66 was one of the first realesed by Intel. Only 486 I had was the DX/33 which I bought in '92.

RE: Article has a misleading title
By dondino on 6/23/2009 10:22:51 PM , Rating: 2
Intel stopped with 486's at 100mhz. The fastest 486DX was by AMD @ 133Mhz. Arguably between the speed of an Intel Pentium 66 and 75.

RE: Article has a misleading title
By Ammohunt on 6/24/2009 2:24:21 PM , Rating: 2
Thats only half correct AMD put out a 486DX-80 which ran at multiples of 40mhz which at the time the intels only ran at 33 mhz i.e. 486DX-66; 33mhzx2 Those particular AMD 486's were the faster.

RE: Article has a misleading title
By dondino on 6/25/2009 12:17:36 AM , Rating: 2
I'm not sure where I've stated any false info. True, the DX2 maximum with AMD was a DX2-80. However, they made DX4 variants to 120Mhz, the Am486. Their Am5x86 (also pin compatible with Intel 486 processors) was made at a max of 133mhz, making it the fastest commercially available 486 ever, on par with a Pentium 75.

By winterspan on 6/28/2009 10:16:10 PM , Rating: 2
486? How OLD are you guys?? :)

"There is a single light of science, and to brighten it anywhere is to brighten it everywhere." -- Isaac Asimov
Related Articles

Copyright 2016 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki