backtop


Print 17 comment(s) - last by MrPoletski.. on Jun 8 at 6:19 AM


Researchers have created the world's first flexible memristor, which could one day be used as a memory device in MP3 players and other electronics.  (Source: NIST)

Researcher Nadine Gergel-Hackett manufacturers one of the memristors, using an inexpensive new deposition method. The new manufacturing technique is somewhat like making Jello.  (Source: NIST)

The resulting memristor is flexible, and includes all the great perks of memristors, including low voltage requirements and holding its state (memory) when powered off.  (Source: NIST)
Element could be used in MP3 players and other mobile devices

HP made headlines when it developed the memristor, a long-theorized, but never proven fourth electronic circuit element.  Called by some the "holy grail" of electronics research, the element held great promise for creating cheaper, more efficient memory

Since the development memristor research has boomed, and researchers with the National Institute of Standards and Technology now have reported an exciting development -- a flexible memristor.  To develop it, research combined polymer sheets (similar chemically and physically to transparencies) and titanium dioxide (a common ingredient in sunscreen).  Best of all, rather than using expensive deposition equipment for the titanium dioxide, an experimental sol gel process was used.  Under this process, the material in liquid form is spun, then allowed to set into a solid, similar to Jell-O.

States NIST researcher Nadine Gergel-Hackett, "We wanted to make a flexible memory component that would advance the development and metrology of flexible electronics, while being economical enough for widespread use.  Because the active component of our device can be fabricated from a liquid, there is the potential that in the future we can print the entire memory device as simply and inexpensively as we now print a slide on an overhead transparency."

Intriguingly, while the researchers did not set out to create a memristor, it appears they have created one.  A memristor is technically a resistor that changes its resistance depending on the amount of current that is sent through it—and retains this resistance even after the power is turned off.  It is considered a fourth circuit element in addition to resistors, capacitors, and inductors.  The device indeed holds the properties of a memristor, and the team appears to have created the first flexible memristor.

The resulting memristor can run on only 10 volts and maintains memory even when powered off.  It was flexed 4,000 times and still remained functionality.

The researchers now plan to fully explore the possibilities of the patent-pending technology.  They hope to also find applications for the new technology, including memory for flexible MP3 players and for flexible medical sensors, such as heart rate or blood sugar monitors. 

A paper on the research has been published in the journal IEEE Electron Device Letters.



Comments     Threshold


This article is over a month old, voting and posting comments is disabled

RE: well
By mindless1 on 6/6/2009 12:10:53 AM , Rating: 2
Ok, relatively speaking no other electrical components need so high as 10V, unless talking about CCFL backlighting. Even so, it is not uncommon to have power regulation circuits in devices so one is a boost instead of buck circuit.

The real question is cost and memory density, if it does not beat existing flash tech on both fronts, it may not be all that great a tech for items that have other earlier points of failure. Drop an MP3 player and it isn't the lack of flash chip flexibility that's likely to kill it. We might even argue that the last thing a rigid circuit board with many other non-flexible parts on it needs is a memory chip that can flex.

I'm sure there are good applications, just doubting the consumer electronics products we already have are some of them.


"It looks like the iPhone 4 might be their Vista, and I'm okay with that." -- Microsoft COO Kevin Turner














botimage
Copyright 2014 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki