The IBM Technology Alliance -- including IBM, Chartered Semiconductor Manufacturing Ltd., GLOBALFOUNDRIES, Infineon Technologies, Samsung Electronics, Co., Ltd., and STMicroelectronics -- have announced that they have jointly defined and are developing a 28nm, high-K metal gate (HKMG), low power CMOS process technology.
IBM reports that the 28nm technology can provide power-performance and time-to-market advantages for makers of a variety of power-sensitive and consumer electronics devices like MIDs and smartphones. The new technology creates improved leakage characteristics that will optimize battery life for next-gen mobile devices.
The alliance has outlined a migration path from the current 32nm process that is being used to the new 28nm technology that requires no costly and time-consuming redesign of the components according to IBM.
IBM's Gary Patton said in a statement, "Through this collaboration, IBM and its alliance partners are helping to accelerate development of next-generation technology to achieve high-performance, energy-efficient chips at the 28nm process level, maintaining our focus on technology leadership for our clients and partners."
IBM says that early work with some clients has shown that the 28nm technology can provide a 40% performance improvement while saving up to 20% in power compared to 45nm technology devices. The HKMG implementation also makes for one of the industry's smallest SRAM cells reports IBM at only 0.120 square microns.
ST-Ericsson's Jorgen Lantto said, "This statement of commitment to 28nm low-power technology by the IBM Joint Development Alliance is an important progression from 32nm high-k metal gate technology. Leaders in the mobile industry can utilize 28nm low-power technology to meet the increasingly aggressive demands for performance and improved battery life."
IBM recently walked away from purchase talks with Sun after Sun's board balked at IBM offer.
quote: You're really lucky I'll even dignify your uninformed remarks with a response, but I will.
quote: The Alpha was not an architecture, it was an instruction set,
quote: and what made it fast, when it was, was that DEC's implementations were extremely expensive.
quote: There was nothing special about the instruction set, and many times during the lifetime of it, POWER was faster.
quote: Initially, it was a very high clock speed processor, whereas the POWER was IPC, but even that changed over time. Anyway, I was asking based on what was he saying the K7 was brilliant. In reality, it had nothing brilliant and was a prosaic design.
quote: Your remarks about processors coming out and not have good performance initially is absurd and ignorant. It didn't even make sense with respect to the Athlon, which initially did have a performance edge of the Pentium III. The Conroe raped the Pentium 4 and K8, and the i7 beats the Penryn, but you stupidly compared the low end with the high end. The fact remains, the high end i7 easily beats the high end Penryn. And it's very closely based on it.
quote: The Coppermine was based on the Pentium Pro, which was released in 1995. The Pentium II made some minor internal changes, mostly to run 16-bit software, since segmentation is rarely used in 32-bit software (well, technically, it is, but they use a 32-bit segment so it's irrelevant). The Pentium III was a Pentium II with SSE, nothing more. The Coppermine was a Pentium III with a different L2 cache arrangement, being on die instead of going through the "back-side bus".
quote: The 1.13 Pentium IIIs they pulled from the market were Coppermines, not Tualatins. They later found out it had problems with the L2 cache at that clock speed. The Tualatins could overclock easily to 1.6 GHz, but Intel priced them very high and keep the memory bus speed limited to 133 MHz.
quote: Nehalem is not a brand new architecture, it's very similar to the Penryn internally.
quote: The changes are mainly with the cache and memory architecture, and sometimes not even for the better (for example, the L1 cache is slower).
quote: You really need to do some reading before say things like this, it's very uninformed, especially since Intel doesn't even know it's a new architecture. Nor does AMD know the Phenom II is brand new. They thought the Bulldozer was going to be the new one. Maybe you should tell them so they don't do something really stupid. They need to know!
quote: The K8 was not even close to the first processor to move the memory controller to the processor.
quote: Intel didn't do it not because it was so difficult, but because it made no sense to.
quote: The Pentium 4 was too big, and the Conroe was better served with larger cache memory. With 45nm, it finally made sense.
quote: If you think the K8 was the first, look at the NexGen 586 processor, which came out in the mid-90s. There was nothing new about it. That doesn't make it a mistake, but it doesn't make it an innovation either.
quote: The Pentium III was limited by it's bandwidth tremendously, and that made RDRAM ill suited for it.
quote: The 840 chipset for the Pentium III was better though, having lower latency. But the Pentium III was just stuck with a single pumped bus, unlike the Athlon which was doubled, and the Pentium 4 which was quad-pumped. Both had much higher bandwidth and that crippled the Pentium IIIs performance.
quote: RDRAM was very effective with the Pentium 4, by the way, because the Pentium 4 could take advantage of its bandwidth.
quote: The Pentium III could not, and had the same problem with DDR, although DDR did not have the latency issues of RDRAM.