backtop


Print 33 comment(s) - last by Regs.. on Feb 18 at 1:12 PM

New material should give a boost to the hydrogen economy

Many believe that hydrogen is the eventual replacement for gasoline and that future vehicles will be fuel cell-based plug-in hybrids.  However, in order to transition to such a hydrogen-based economy, many key challenges remain.  The biggest challenges are devising and implementing means to make, store, and ship hydrogen to distribution centers.

One of the key challenges in making hydrogen is the need for purification.  Many chemical reactions that produce hydrogen also produce a mixture of hydrocarbon gases and water vapor.  In the past separating these substances has been a tricky and inefficient process.

Now chemists at Northwestern University have developed a class of porous materials that may solve this problem by letting hydrogen gas through selectively, while impeding other gases.  According to the researchers, the materials exhibit the best known selectivity towards hydrogen over methane and carbon dioxide of any known material.

Mercouri G. Kanatzidis, a professor of chemistry at the university and co-developer of the material, states, "A more selective process means fewer cycles to produce pure hydrogen, increasing efficiency.  Our materials could be used very effectively as membranes for gas separation. We have demonstrated their superior performance."

While current separation techniques rely on separating molecules by size, the new porous membrane material separates them by polarizability.  The new membrane, composed of germanium, lead and tellurium, lets hydrogen through faster, as it is a hard, small molecule which interacts little with the charged walls.  The membrane is a hexagonal nanoporous structure, with parallel tubes about two to three nanometers wide.  The gas molecules are at least half a nanometer wide.  The membrane selects hydrogen at a rate approximately four times higher than the current best methods.

Professor Kanatzidis describes the material stating, "We are taking advantage of what we call 'soft' atoms, which form the membrane's walls.  These soft-wall atoms like to interact with other soft molecules passing by, slowing them down as they pass through the membrane. Hydrogen, the smallest element, is a 'hard' molecule. It zips right through while softer molecules, like carbon dioxide and methane take more time."

The membrane operates within a "convenient temperature range" of zero degrees Celsius and room temperature.

Professor Kanatzidis worked closely with postdoctoral research associate Gerasimos S. Armatas on developing and testing the material.  The pair has published a paper entitled "Mesoporous Germanium-Rich Chalcogenido Frameworks with Highly Polarizable Surfaces and Relevance to Gas Separation".  It is published online at the journal Nature Materials.



Comments     Threshold


This article is over a month old, voting and posting comments is disabled

RE: stupid question...
By jaybuffet on 2/17/2009 10:59:20 AM , Rating: 2
A quick search on google turned up a 0.158 kw hours per cubic foot number for generating hydrogen from water using electrolysis. If this is true, then I would need 61.3 kwh to fill 388ft^3. My coned bill says a kwh costs me $.12. So that would equate to $7.36 to go 90 miles (if this was gas, and i'm getting 30mpg, thats equivalent to $2.45/gal)


RE: stupid question...
By freeagle on 2/17/2009 11:06:08 AM , Rating: 2
But that only calculates the cost of produced hydrogen. You need additional energy to squeeze the 388ft^3 of hydrogen into a conventionally sized tank. My guess it won't be very cheap.


RE: stupid question...
By jaybuffet on 2/17/2009 11:16:59 AM , Rating: 2
who says we need a conventional tank :-) lets throw a tank on the roof.. there enough space up there for a tank 5ft wide, 4ft long, 2ft tall.... might look goofy in the beginning.. but what doesnt..


RE: stupid question...
By freeagle on 2/17/2009 11:22:01 AM , Rating: 2
Since you've been talking about reducing weight.... do you realize that 5x4x2 ft tank for storing pressurized hydrogen would add significant amount of weight to the car?


RE: stupid question...
By jaybuffet on 2/17/2009 11:32:34 AM , Rating: 2
not pressurized... but the weight reduction seem moot (another site said 1 ft^3 at STP lifts 0.07lbs, so 388ft^3 would only lift 27lbs, probably less than the container)

this sounds too feasible.. i must have messed up a calc somewhere


RE: stupid question...
By freeagle on 2/17/2009 11:38:55 AM , Rating: 2
quote:
not pressurized


5x4x2 ft can store only 5x5x2ft^3 of unpressurized H2. If you wan to put 388ft^3 of into that space, it has to be under pressure


RE: stupid question...
By jaybuffet on 2/17/2009 11:48:51 AM , Rating: 2
i'm dumb +1. So anyways, i wonder how much energy that would take to compress the hydrogen. I guess thats what this whole issue is about... hydrogen storage.. that took a long time for me to get it


RE: stupid question...
By freeagle on 2/17/2009 11:55:51 AM , Rating: 2
The whole issue is about efficient production and storage. We need to store much more hydrogen than those 388ft^3 you calculated, because 90 miles driving distance is not much compared to what you get with full tank of gasoline. We also need to figure out a way to cheaply produce a lot of hydrogen. For now, storing the energy in batteries is more effective.


RE: stupid question...
By jaybuffet on 2/17/2009 12:03:27 PM , Rating: 2
i would think 90 miles would be more than enough for peoples daily driver. i mean, my calculation came to the equivalent of $2.45 per gal of gas.. which isn't too bad.. add on the cost of compressing it.. not sure what is involved there cost wise.. i wouldn't think it would be substantial since we're not talking a huge compression (10:1), though i could be wrong. at least we would reduce our dependency on foreign oil.. efficiencies can only go up.. (gov't wouldn't get its taxes though, so they would probably make the production of hydrogen illegal much like marijuana)


RE: stupid question...
By codeThug on 2/17/2009 4:31:10 PM , Rating: 2
stop. stop.

I can't take anymore...


"I'm an Internet expert too. It's all right to wire the industrial zone only, but there are many problems if other regions of the North are wired." -- North Korean Supreme Commander Kim Jong-il














botimage
Copyright 2014 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki