Print 24 comment(s) - last by jlips6.. on Aug 19 at 8:13 PM

Researcher Steven Novack with the U.S. Department of Energy's Idaho National Laboratory showcases the arrays of nanoantennas print on plastic. The material, developed by his team, could yield breakthroughs both in cooling and in solar power collection.  (Source: U.S. Department of Energy's Idaho National Laboratory)

A view of the nanoantennas taken by an electron microscope.  (Source: U.S. Department of Energy's Idaho National Laboratory)

The new material is very flexible and could be printed at a rate of "yards per minute" according to Mr. Novack.  (Source: U.S. Department of Energy's Idaho National Laboratory)
New technology could one day cool PC components and recharge consumer electronics, collecting energy even at night

Imagine your iPod or Blackberry has lost its charge.  Now imagine taking it out of your pocket and laying it on your desk in you cubicle for a few minutes.  After soaking up the light for a few minutes, the phone powers back to life with enough juice to make a call.  No, it wouldn't be by magic, rather this is the scenario envisioned by researchers at the U.S. Department of Energy's Idaho National Laboratory who have developed a unique kind of flexible solar cell.

The new cells consist of massive arrays of nanoantennas, which can collect energy from light and other sources.  The INL team discovered a way to mass produce these arrays on flexible sheets of plastic.  The only crucial problem remaining unresolved is developing additional components to harvest the collected energy by transforming it to electricity.

At the American Society of Mechanical Engineers 2008 2nd International Conference on Energy Sustainability, engineers from the INL presented their findings and revealed their visions of the tech which they hope will one day cover cars and consumer electronics in replenishing skins.  The skins could also act as cooling devices by drawing away waste heat, according to the researchers.

The nanoantennas absorb a targeted wavelength range of mid-infrared rays.  The Earth continuously emits these rays thanks to the solar energy that it absorbs during the day.  This would allow for continuous solar panel operation, in theory.  Traditional panels can only absorb visible light and thus are idle at night.

The INL physicist who led the team, Steven Novack, describes, "Every process in our industrial world creates waste heat.  It's energy that we just throw away."

Mr. Novack worked with INL engineer Dale Kotter, W. Dennis Slafer of MicroContinuum, Inc. and Patrick Pinhero, now at the University of Missouri to design the nanoantennas -- tiny gold squares or spirals set on polyethylene, a plastic commonly found in plastic bags.  The effort marks perhaps the first successful effort to capture infrared rays with nanoantennas.  Past efforts have been able to harvest other lower-frequency wavelengths but have fallen short with high-frequency wavelengths like IR.  This is due in part to the fact that materials' properties change at high frequencies.

Gold was selected after testing it, manganese and copper's reactions to IR rays.  After careful computer design, an antenna which could collect 92 percent of the energy from infrared rays was achieved in theoretical simulations.

Next, the researchers moved to making a prototype, etching silicon wafers with the antenna pattern.  A just slightly less efficient prototype was produced that harvest 80 percent of the energy.  Finally a stamp-and-repeat method was used to emboss thousands of the antennas on thin sheets of plastic.  The plastic skin produced is currently undergoing efficiency testing, but is expected to perform similarly to the first prototype.

As heat typically is emitted as IR rays from many objects, the antennas could cool objects by collecting these rays and reemitting them at a harmless wavelength.  This could be used on a large scale, or on a smaller scale for computer component cooling.

A major obstacle remains in that though the device already produces alternating current, it alternates at a rate of trillions of times per second, far to fast for modern rectifiers to convert to DC current.  Further, the current smallest rectifier would need to be shrunk to a thousandth of its size to fit next to the nanoantenna.  This would require new manufacturing techniques.  An alternative might be to develop nanodevices to slow down the alternating current to more manageable levels.

The light at the end of the tunnel, so to speak, should these problems be overcome, is the production of much cheaper and more efficient solar cells.  Current cells only have an efficiency of around 20 percent, due to the inherent inefficiency of the chemical reactions used to harvest visible light.  More exotic cell materials have promised higher efficiencies, but they remain too expensive and difficult to utilize.

Nanoantennas on the other hand can harvest rays much more efficiently.  Further, they can be formed in multiple layers, with each layer tuned to a different part of the spectrum based on the antenna design.  Mr. Novack imagines manufacturers to eventually be producing "several yards per minute" of the material.

The program is a part of the U.S. Department of Energy's ongoing alternative energy investments

Comments     Threshold

This article is over a month old, voting and posting comments is disabled

By rtrski on 8/12/2008 9:29:32 AM , Rating: 2
Look, all they did is come up with an antenna that's resonant in the mid-IR, and produce it on a thin film plastic. That's kind of neat, and a nice first step. But otherwise totally meaningless to all the BS speculation presented in the article and the linked pages.

"Could absorb IR and re-emit at lower wavelengths..." Nothing remotely demonstrated about this. An antenna is simply a coupling mechanism between free-space EM and some form of 'guided' EM mode, antennas are PASSIVE. They don't do frequency multiplication or division. They trap a wave out of the air into a circuit, but it's still at the same frequency, and has to then go somewhere. Otherwise, it comes right back out.

Spiral antennas, square slots, split-ring resonators, etc have all been around forever. Simple wavelength scaling lets you "design" them for almost any frequency range you want. But etching techniques and tolerances might mean you can't get the desired linewidth and spacing for a given application. The only 'new' thing here is that they managed to get a small enough pattern placed on a thin, flexible, and inexpensive material. But without something to connect to, reciprocity says if you receive, you radiate as well. All that mid-IR frequency EM "captured" by the antenna has got to go to a load circuit of some kind, or else it's reflecting right back out as soon as it hits a discontinuity (less some dissipative losses).

If they're just 'block stamping' the antenna pattern, it would be interesting to hear how well they aligned the pattern 'blocks' (certainly they're not stamping each individual spiral, but larger groups thereof). Without the ability to line up your circuitry, you can never realize a larger array. Without the right registration tolerances you're also never connecting any sort of circuitry to these antennas to keep whatever EM they received in the first place.

I'm really becoming more and more disillusioned by the "science" reporting here at Dailytech. Michael still has some pride of authorship, but certain other authors are either ignorant or lazy enough to just parrot whatever grandiose claims anyone else posts (nearly word-for-word, no less) without even performing a basic sniff test.

By jido on 8/12/2008 6:59:24 PM , Rating: 2
The manufacturing first is important. It will likely have applications.
From the comments I understand that should not be called a solar cell, except if we solve the issue of the rectifier. It is an antenna (not even tuned to the sun radiations).

BTW how does the rectifier work? Does it dephase the signal to generate a non-alternated mostly-flat output? If so could the same be achieved with several antennas oscillating with a slightly different phase.

"A lot of people pay zero for the cellphone ... That's what it's worth." -- Apple Chief Operating Officer Timothy Cook

Copyright 2016 DailyTech LLC. - RSS Feed | Advertise | About Us | Ethics | FAQ | Terms, Conditions & Privacy Information | Kristopher Kubicki